how to remove shower drain cover that is grouted in

Not sure of the brand - may be Kohler or Hansgrohe. The parts of the shower drain include the strainer strainer body shower pan rubber gasket and drain bodyIt may become necessary to remove a shower drain due to water leakage through some of the interlocking parts.

How To Easily Remove Shower Drain Cover Unclog Drain In 1 Minute Jonny Diy Youtube

A clean damp cloth.

. The drain cover is square and is 375 inches per side. Youll need some tools to extract them properly from the shower floor. There are no visible slots for screwsbolts.

Those drain covers can be removed by first pushing on the cover to open it. Standard and screw-in drain covers are slightly harder to remove. I called my contractor and he hasnt returned my call.

How to Remove Shower Drain Cover. Remove as much of the tailpiece as you can and clean out the trap with a shop-vac andor spoonwireetc. Of bigger concern and no real way of knowing is the offset.

Stick a screwdriver in one of the outer holes and then hit the screwdriver with a hammer just above where it goes into the hole while holding the screwdriver handle steady. Work a snake down the drain and whip it around like crazy while running LOTS of water In the hope that youll wash enough of the grout further downstream that a your drain runs quickly again and b it doesnt clog your pipes further down the line where you cant get at it. From the open position lift and look for a set screw.

You want to lightly fracture the bond between the strainer and the grout. Buy a drain or spray lubricant like WD-40 silicone lubricant or PTFE. My contractor grouted in my shower drain.

Take some lubricant and spray it into the lip of the drain cover. Rinse the sponge often while wiping. I suspect the issue is a large wad of my daughters long hair down in the drain.

Attempt removing the drain now and watch it come out. Use the lubricant on the shower drain area. An older drain may not readily come out even after it has been unscrewed.

If you see a small screw turn it with a flathead or Allen wrench until just loose enough to remove stopper not entirely. Regardless of what you immediate solution is you can try to gently separate the drain cover from the grout by applying some upward force screwdriver in the holes is fine and working around it tapping gently with a hammer or directly at the edge with a screwdriver or something thinner. Wipe the grout line the tile and the inside edge of the drain with a damp sponge to remove excess grout.

Because it is much easier to make poor square cuts than make the round cuts required in the tile to go with the drain cover that came with the drain body. Allow the lubricant to sip into the drain for about 5-10 minutes. You likely will loose some grout when its removed but its cosmetic and learning to repair that will be one of your new things to learn about DIY.

When I use the key to lift up the drain and it wont budge. Insert the screwdriver on the screw and turn it until it comes out. 1 Baking soda vinegar 2 Plumbers Snake I havent tried option 1 yet but 2 seems impossible unless I can remove this shower drain.

To get it off lightly tap it with a dead blow hammer rubber mallet or a steel hammer covered in a couple layer of towel. If your drain is rusty WD-40 is ideal1 X Research source Do not pour grease or fat down your drain in an attempt to loosen itStep 2 Check your drain for clogs. Screw-In Snap-On More Liam McCabe Blog Youre probably reading this because youre tired of standing in a pool of dirty soapy water every time you take your showerThe thing is a slow bathtub drain is.

How do I go about getting this drain moving. Use a dry towel to clean up the drain so that the lubricant will be enough. Any info about the tool type tool name and an online source would be.

There are 5 round drainage holes on each side for a total of 25. Begin by giving the tile a good cleaning with a sponge and soapy citric-acid water as a descaling solution and use a toothbrush to deep clean grout to remove deposits and stains that may make removal more challenging. 1 tsp citric acid.

Ensure to use the right amount of the lubricant so it gets into the drain. This will force it to twist out of the grout looks like it was grouted in place. The strainer portion of the shower drain is visible when standing in the shower.

I moved into a place with a shower where the shower drain has been grouted in. Pop-Up Drain Covers Some pop-up drain covers pull straight up and off. I need to remove the rectangular drain cover in the shower.

Wait for one or two minutes. 1 Remove the grate by cutting around the grout with a utility knife or trying to pry the outer edges with a screwdriver and digging into the grout 2 Clean drain with a snakeplunger. Use Lubricant And A Screwdriver.

My shower is not draining fast enough lately. I stood in 1 inch of water which I. Heres a few tips for you.

Sep 29 2005. With the cap raised you can twist it counterclockwise to unscrew it and open up your drain. The screw may not turn easily.

Should not have any bearing on your shower performance only if you need to clean hair out of the drain will you find an issue. Others must be wiggled back and forth. There are multiple things wrong with this picture but Im most concerned about 1 being able to remove the drain cover should we have need to clean it out and 2 will there be leakage around the left side where theyve tiled over the edge of my drain.

Step 1 Purchase a drain lubricant to loosen the shower drain. If no screw simply turn counterclockwise to remove. Im noticing that my shower drain is clogged and from research online Ive found two methods for solving this.

If a screw attaches to the drain cover you will take a screwdriver. You may be able to see from the picture that the drainscreen is grouted in--removing the screws wont remove the screen.

How To Remove A Shower Drain Cover Benjamin Franklin Plumbing Duncanville